Installation Guide

14ENIGMA-XO manual Ver 1 Rev 2 03/2018

Fig 9

inside

1 2 3

Fig 10a

Fig 10b

for 72” model

8. Once the Upper Guide Rail (#03) is level, mark the position of the Wall Bracket (#19) and Guide

Rail Brackets (#08) on the wall.

*NOTE:

If installing the 72” model, also mark the position of the Wall Bracket (#19) on the opposite

wall for the Small Stationary Panel Glass (#23) (see Fig 9.4*). (Fig 9)

9. Make sure that the Stationary Glass (#02) is parallel to the front edge of the threshold and mark it.

Slide the Guide Block (#12) into the notch of the Stationary Glass (#02), and align flush with the edge

(Fig 10a). Mark its position and also mark the hole for drilling using a pencil (or center punch.)

Note: If installing the 72” model, also position the Small Stationary Glass Bottom Bracket (#22) with

the edge of the Small Stationary Glass (#23) (Fig 10b) and mark its position and the hole for drilling.

(Fig 10a and 10b)