Installation Guide

ENIGMA-XO manual Ver 1 Rev 2 03/2018

3M TAPE

1 2

3 4

Fig 26

Inside

NOTE: The surfaces need to be clean and free of

construction debris before installing the bumper.

Wipe the area with an alcohol swab before installation

The Bumper (#30) is reversible for

Left (as shown below from inside the

shower) or Right wall installation

Door

Panel

TIP: Use caution if using the screw method

to not crack the wall/tile and to avoid any

plumbing behind the wall.

26. To install the Bumper (#30) with the screw method, position the bumper (#30) onto the

threshold and against the wall on the stationary panel side of the installation. (For 72” model, this will be

the side of the opening with the large stationary panel). and mark the position of the hole onto the wall.

Drill a 5/16” hole and insert the anchor (###). Remove the 3M Tape and position the Bumper (#30) onto

the threshold against the Wall Bracket (#19) and attach using the ST4.2 x 40 Countersunk screw.

(Fig 26)