Installation Guide

Preparation

Do Not hang or drape a towel or wash cloth over the Enigma series guide rail as this

may cause the roller wheels to get stuck and possibly cause serious damage or injury.

Attention: This door is extremely heavy and requires professional installation.

Two installers recommended.

NOTE: This door is reversible for right or left-hand door installation. The right-hand door

installation is shown as an example throughout this manual. For the left-hand door installation,

simply begin on the opposite wall and reverse the orientation of the steps shown.

1. After opening all boxes and packages, read this introduction carefully. Check that all of the needed

parts are included in the package by marking all the components on the “Detailed Diagram of Shower

Door Components”. Examine boxes and packages for shipping damage. If the unit has been damaged,

has a finishing defect, or is missing parts, please contact our customer support department within

3 business days of the delivery date. Please note that DreamLine

will not replace any damaged

products or missing parts free of charge after 3 business days or if the product has been installed.

Please contact DreamLine

if you have any questions.

2. Please note that you should consult your local building codes with questions on installation

compliance standards. Building and plumbing codes may vary by location, and DreamLine

is not

responsible for code compliance standards for your project and will not accept any returns.

3. If this unit is going to be installed in a new construction, install all of the required plumbing and

drainage before installing the shower. Use a competent and licensed (if required by local code)

plumber for all plumbing installation.

4. Make sure that prior to beginning the installation, the surfaces are leveled and solid and will be able to

support the total weight of the unit. Also make sure the walls are at right angles. Irregular

installation surface level, radius corners or improper angle of side walls will result in serious problems for

your installation. Please note that some adjustments and drilling might be necessary during the

installation process.

5. Protect all primary surfaces of the product during installation. Never set your glass down directly onto

a tile floor. Leave corner protectors in place until necessary to remove them. Always use a piece of wood

or cardboard to protect the bottom edge and corners of the glass prior to and during installation.

6. This unit must be installed upon a finished threshold and against finished walls.

7. NOTE! This door does not have out-of-plumb adjustment. Make sure your walls are at right angles.

8. This door requires a minimum 2-3/4”of flat threshold space for installation.

9. Note: The installation of this unit requires that you drill down into the threshold.

10. Please note that Step #11 has an option for installing the guide rail brackets to the wall using

anchors. However, the manufacturer strongly recommends installing these heavy doors to the

studs or to pre-installed 2”x 6” wood reinforcements behind the wall in the area where the guide

rail brackets will be attached to the wall.

5ENIGMA-XO manual Ver 1 Rev 2 03/2018