Installation Guide

ManualsBrandsDreamLine ManualsBathEnigma-XO 55-59 in. W x 62 in. H Fully Frameless Sliding Tub Door in Polished Stainless Steel

17ENIGMA-XO manual Ver 1 08/2017

Ø5/16”

(8mm)

1 2

4**

3**

Ø3/8”

(10mm)

see Note

Fig 11

Fig 12

Ø3/8”

(10mm)

see Note

5** 6**

Separate the Guide Rail Bracket (#08)

sleeve from the base by loosening the set

screws (leave the sleeves on both ends of

the upper guide rail)

base

sleeve

Ø5/16”

(8mm)

7 8

for 72” modelfor 72” model

for 72” model

11. Drill a hole for the Wall Bracket (#19) using a Ø5/16”

(8mm) drill bit and insert the Wall Anchor (#9b)

(see Fig. 12.1 and 12.2).

For the 72“ model, repeat this step for the Wall Bracket (#19)

for the Small Stationary Panel Glass (#23). (Fig 12.7 and 12.8)

Drill the holes for the Guide Rail Brackets (#08) using a

Ø3/8” (10mm) drill bit and insert the Wall Anchors (#9a).

(see Fig. 12.3**~ 12.6**).

**If installing into a stud (recommended), drill a Ø1/4” hole

and do not use the wall anchors (see note above). (Fig 12)

10. After marking the positions of all the hardware, set the

Stationary Glass (#02) with the Upper Guide Rail (#03) aside.

(If installing the 72” model, also remove the Small Stationary

Panel Glass (#23) from the Upper Guide Rail (#03)).

Remove the Guide Rail Brackets (#08) from the Upper Guide

Rail (#03) and the Wall Bracket (#19) from the Stationary

Glass (#02). Place the Wall Bracket (#19) and Guide Rail

Brackets (#08) back to the outlined positions and mark the

holes for drilling.

*NOTE: If installing the 72” model, perform the same

procedure on the opposite wall to mark the Wall Bracket (#19)

for the Small Stationary Panel Glass (#23) (see Fig 11.4*).

(Fig 11)

**NOTE: Step #11 has an option for installing the guide

rail brackets to the wall using anchors. However, the

manufacturer strongly recommends installing these heavy

doors to the studs or to pre-installed 2”x 6“ wood

reinforcements behind the wall in the area where the guide

rail brackets will be attached to the wall.

**For the recommended installation into a stud, drill a Ø1/4”

hole up to the stud, do not use wall anchors, and let the

screw bore into the wood.