User Manual

19ESSENCE-H manual Ver 1 05/2017

Fig 17

Fig 18

decorative cap

Ø5/16”

(8mm)

NOTE: Do Not overtighten the screws

as this may deform the wall profile.

16. Apply silicone to the back surface of the Wall Profile (#19)

and

place it back in position on the wall.

Align the Bumper Guides (#20) with the correct holes and

attach them to the wall through the Wall Profile (#19) using

the ST4.2 x 40 Round Head Screws (#23). Cover the screw

holes with the supplied decorative caps. (Fig 18)

15. Remove the Upper Guide Rail (#01). Remove the Guide Rail Bracket Assembly (#02) from the end

of the Upper Guide Rail (#01) and hold it in position on the Wall Profile (#19) at the mark from the

previous step.

Mark the center of the holes on the wall for drilling through the elongated holes in the wall profile. Also

mark the holes on the wall for the two Bumper Guides (#20) through the holes in the Wall Profile (#19).

Drill the holes using a Ø5/16” drill bit and insert the Wall Anchors (#18). (Fig 17)