User Manual

ESSENCE-H manual Ver 1 05/2017

Fig 25

disk

2.5mm allen wrench

cap

disk

wheel

small hole

TIP: The wheel assembly bushing that fits through the hole in the glass is elliptical.

By rotating this disk, the door glass can be adjusted (tilted) slightly in order to make even

contact with both the top and bottom wall bumpers.

◾ Use a shim beneath the door glass to prevent contact with the threshold during adjustments

◾ Temporarily adjust the roller guards for clearance

◾ Remove the cap from the wheel assembly and loosen the bolt

◾ Insert the small 2.5mm allen wrench or similar into the small hole in the edge of the

adjustment disk to help rotate the disk (see Fig 25) and tilt the door glass into the

desired position

◾ Hold the glass in position and re-tighten the bolt

◾ Test the operation of the door. Repeat on the other wheels as necessary

◾ Replace the Wheel assembly cap

◾ Re-adjust and fully tighten the roller guards to within 1/16” of the Upper Guide Rail (#01)

(See Fig 24 and Fig 25)