Installation Guide

Installation Steps

ENIGMA AIR manual Ver 1 Rev 5.2 02/2018

NOTE: The right-hand door

installation is shown as an example

throughout this manual. For the

left-hand door installation, simply

begin on the opposite wall and

reverse the orientation of the steps

shown.

Fig 1

Fig 2a

1. Check both of the nished walls for plumb and the

threshold for level. (Fig 1)

NOTE: This model does not allow for out-of-plumb

adjustment.

2. Use a chop saw (or a hacksaw) to cut the

stainless steel Guide Rail (#04) from the door end

only to fit the finished opening.

Measure the finished opening width at the model

height:

◾for Shower model: Measure the width at a height

of 72-1/4”

◾for Tub model: Measure the width at a height of

58-1/4”

This will be dimension (W).

The Guide Rail (#04) is 1“ less than the model size

and will need to be cut to 1” less than the

finished opening size (W):

Finished opening (W) - 1” = finished cut length

(Fig 2a and Fig 2b)