Installation Guide

ENIGMA AIR manual Ver 1 Rev 5.2 02/2018

Ø1/4"

or 5/16”

2**1* 3

Fig 7

*NOTE: Installation of the Guide Rail

brackets into a stud or 2” x 6” wood

reinforcement is strongly recommended.

**NOTE: When installing to a stud, drill

a Ø1/4” hole up to the stud and do not

use the anchors.

Fig 8

inside

tighten these set screws

to the wall bracket (6b)

and use to adjust the

guide rail to level if

necessary

The guide rail wall

bracket should be

centered in the

bracket as shown

to allow for vertical

adjustment both

up and down.

Note that the bottom of the

bracket is thicker than the top

and must be installed correctly

(=)

top

bottom

8. Drill either a Ø5/16” hole and insert a Wall Anchor (#16), (OR when installing to a stud, drill a Ø1/4”

hole up to the wood and do not use an anchor.)

*See notes below.

Separate the Guide Rail Bracket (#06) components (Fig 6a and Fig 6b).

Install the Guide Rail Wall Bracket (#06b) to the wall using one ST4.2 x 55mm Countersunk Screw

(#21). (Fig 8)

7. Hold the Guide Rail Bracket (#06) in the

marked position and mark the hole for drilling

through the Guide Rail Bracket (#06) using a

pencil (or center punch). (Fig 7)