Installation Guide

ENIGMA AIR manual Ver 1 Rev 5.2 02/2018

1-1/4”

Fig 17

Fig 18

1-1/4”

measure from

the plumb line to

the edge of the

bracket inside

the shower

with the guide

rail level, mark

the bottom

position of the

bracket on the

wall

1-1/4”

To lower the rail:

Loosen the top set screw and

tighten the bottom set screw.

To raise the rail:

Loosen the bottom set screw and

tighten the top set screw.

NOTE: It is important

that the guide rail is

level when marking

the position of the

Guide Rail bracket on

the wall.

17. Level the Guide Rail (#04) across the opening.

If necessary, use the set screws on the Guide Rail Bracket (#06)

to adjust the level of the Guide Rail (#04) and then fully tighten

the Glass Brackets (#07). (Fig 17 and Fig 18)

18. Using the reference mark on the

door-side of the threshold from Step #3,

draw a plumb line up the wall on the door

side of the opening. Measure over 1-1/4”

into the shower from this line. With the

Guide Rail (#04) level, mark the position of

the Guide Rail Bracket (#06) on the wall.

(Fig 18)