Installation Guide

ENIGMA AIR manual Ver 1 Rev 5.2 02/2018

**NOTE: When installing to a stud, drill

a Ø1/4” hole up to the wood and do not

use the anchors.

1 2* 3** 4

Ø1/4"

or 5/16”

1 3

4 5 6

*NOTE:

Installation of the Guide Rail

brackets into a stud or 2” x 6” wood

reinforcement is strongly

recommended.

Fig 19

Fig 20

inside

19. Remove the Guide Rail (#04) from the Stationary Panel Glass (#02). Remove the Guide Rail

Bracket (#06) from the Guide Rail (#04) and hold it back in position on the wall and mark the anchor

hole. Drill either a Ø5/16” hole and insert a Wall Anchor (#16), OR when installing to a stud, drill a

Ø1/4” hole

up to the wood

and do not use an anchor. *See notes below.

Separate the Guide Rail Bracket (#06) components (Fig 6a and Fig 6b). Attach the Guide Rail

Wall Bracket (#06b) to the wall using one ST4.2 x 55mm Countersunk Screw (#21). (Fig 19)

20. Re-attach the Guide Rail (#04) to the Stationary Glass (#02) and attach the Guide Rail

Brackets (#06). (Fig 20)

NOTE: Be careful not to scratch the guide rail with the brackets or set screws.