Installation Guide

ENIGMA AIR manual Ver 1 Rev 5.2 02/2018

Handle holes

Painter’s Tape

Fig 24

Right-hand door installation shown as example

Fig 25

Rotate disk to adjust

NOTE: DO NOT install the handle onto

the door glass until instructed.

DO NOT attempt to lift the glass using the handle.

This could result in damage to the glass and/or

serious personal injury. Always use an assistant

or a professional grade glass suction cup when

handling heavy glass.

To adjust the Rollers (#08): Support the

weight of the door glass with a shim or a

glass suction cup. Loosen the roller bolt

and rotate the adjustment disk to raise or

lower the edge of the door glass. Hold the

adjustment disk in place with a small Allen

wrench and fully tighten the bolt.

25. Attach the Rollers (#08) to the Door Glass

(#03) with the wheels facing out.

NOTE: The roller hardware disk can be rotated to

tilt the door glass slightly to create a tight seal

with the wall. Make any adjustments after all of

the vinyl seals are installed to protect the edge of

the door glass. (Fig 25)

NOTE: Apply Thread Lock (#20) to the

roller bolts during installation.

24. Secure the Anti-Splash Threshold (#11) to the

threshold with several pieces of painter’s tape to hold it

tight to the threshold until the silicone fully cures.

(Fig 24)