Installation Guide

ENIGMA AIR manual Ver 1 Rev 5.2 02/2018

1 2 3 4

door

panel

outside

panel

Fig 27

NOTE: Apply Thread Lock (#20)

to the Roller Guard bolt during

installation.

Fig 28

1 2

Guide Rail

Roller

1 /16"

Roller Guard

TIP: Position the roller guard 1/16”

below the guide rail, hold the roller

guard bolt with the Allen wrench and

tighten the interior post using the

small Allen wrench (Fig 27.2)

28. Attach the Handle (#15) to the Door Glass (#03). Attach the Anti-Water Strips (#13) to the edge

of the Stationary Panel Glass (#02) and to the Door Glass (#03). Attach the Bumper Seal Strip (#14)

to the handle side of the Door Glass (#03). (Fig 28)

27. Attach the two Roller Guards (#09) onto the door glass to secure

the door to the Upper Guide Rail (#04). Apply Thread Lock Adhesive

(#20) to the bolts. Leave no more than a 1/16” gap between the

Roller Guards (#09) and the Upper Guide Rail (#04). Tighten the

post and screw on the cap. (Fig 27)