Installation Guide

ENIGMA AIR manual Ver 1 Rev 5.2 02/2018 27

Ø5/16”

Wall

Inside

Wall

Inside

3M Tape

Wall

3 4

Wall

Fig 30

Inside

NOTE: The surfaces need to be clean and free of

construction debris before installing the bumper.

Wipe the area with an alcohol swab before

installation.

The Bumper (#26) is

reversible for Left

(as shown below

from inside the

shower) or Right wall

Installation

TIP: When using the screw method, use

caution to not crack the wall/tile and to

avoid any plumbing behind the wall.

Extender driver bit recommended

for screw installation method

30. To install the Bumper (#26) with the screw method: Remove the PVC insert and position the

Bumper (#26) onto the threshold against the U-Channel on the stationary panel side of the installation

and mark the position of the hole on the wall. Drill a Ø5/16” hole and insert the Anchor (#16). Remove

the 3M Tape backing and position the Bumper (#26) onto the threshold against the U Channel (#01).

Screw to the wall using the ST4.2 x 40 Countersunk screw. Re-insert the PVC insert. (Fig 30)