Installation Guide

ENIGMA AIR manual Ver 1 Rev 5.2 02/2018

DOOR

OOR

ANEL

1 2 3 4

5 6 87

Panel side

Door side

* Stopper Locations as measured from the wall to the center of the stopper:

• • Panel side: 5” (+/- 1/16“) where the door makes contact with the bottom bumper

• Door side: 3-1/2” (+/-) (depends on opening conditions)

***Position the Panel-side stopper so that the door glass

makes contact with the stopper and bottom bumper at

the same time.

NOTE: Cover the shower/tub drain with tape prior to removing the set screws to prevent loss.

Fig 31a

Fig 31b

position stopper where

door contacts the

SafeStop™ bottom bumper

Stopper

Thread Lock Adhesive

31. Position the Stoppers (#05), remove the set screws from the

Stoppers (#05) and apply Thread Lock Adhesive (#20) to the threads.

Reinsert the set screws into the Stoppers (#05). Correctly position the

Stoppers (#05) and screw them tightly to the Guide Rail (#04) with the

supplied Allen wrench. (Fig 31a)

NOTE: The Stoppers (#05) must be positioned

correctly to prevent the handle from contacting the

Stationary Glass (#02) and to stop the Door Glass

(#03) in a position that allows the bumper strip to

create a seal with the wall, but does not allow the

door glass to bang into the wall during normal

operation. (Fig 31a and 31b)

Door Stopper Installation:

1. Remove the set screws

2. Slide the Door open until it makes contact with the bottom Bumper (#26) to correctly position the

panel side Stopper (#05) on the Upper Guide Rail (#04).

3. Remove the set screw threads and apply Thread Lock Adhesive (#20)

4. Reinsert the set screws into the Stopper (#05) and fully tighten. (Fig 31b)

5. Repeat on the Door side and position the Stopper (#05) so that the bulb vinyl seals evenly with the

wall.