Installation Guide

4ENIGMA AIR manual Ver 1 Rev 5.2 02/2018
©2018 DreamLine. All Rights Reserved
Roller wheels tight with
proper clearance beneath the
door glass and guide block
Roller guards
positioned properly
and tight within 1/16”
beneath guide rail
Guide block screwed down
and square with glass
Stopper properly
positioned and tight
-door stops well before
handle can contact the
panel glass when door
is in the fully open
position
Stopper properly positioned and
tight so that the Door stops against
the stopper and prevents the Door
from making hard contact with the
wall but allows the bulb vinyl to seal
Guide Rail level
To secure the Stoppers (#05):
Apply the Thread Lock adhesive to the
threads of the set screws during the nal
installation. Fully tighten the set screws with
the supplied Allen wrench.
Stopper
Thread Lock Adhesive
Recommend to apply thread lock to:
• Stopper set screws
• Roller guard bolts
• Wheel bolts
• Glass Bracket bolts
ENIGMA-AIR
troubleshooting and
maintenance tips
Roller wheels adjusted as
needed so that the bulb
vinyl seal makes even
contact with the wall
from top to bottom
Guide Rail bracket ush with
wall and set screws tight;
Installation into a
stud strongly recommended
Glass brackets
tight
Panel Glass sits ush
on the threshold
All rubber gaskets and sleeves installed properly between
all hardware and glass to prevent glass to metal contact
Guide Rail
bracket ush
with wall and
set screws
tight
Bulb vinyl seal
installed
The bulb vinyl seal on
the edge of the door
makes even contact
with the wall when the
door is fully closed
Inspect bottom
corners of door glass
for damage.
**Units with
damaged door glass
should not be used
until door glass has
been replaced**
Right Hand door installation shown as an example
Handle tight
Rotate disk to adjust
Bumper is
secured in
position with
3M tape or
screwed to
the wall
Door Glass
Panel Glass
* Stopper Locations as measured from the
wall to the center of the stopper:
• Panel side: 4-3/4” (+/-) (but no less than
4-1/2” )
• Door side: 4” (+/-) (depends on opening
conditions)