Installation Guide

24ENIGMA SKY shower and tub door manual Ver 1 Rev 1 02/2018

Apply a bead of silicone to the wall

or to the back of the U-Channel

Fig 29

Ø5/16"

**Partially insert at two of the U-Channel

Bumper Inserts (#28) at the top and

bottom of the U-Channel (For Door Glass)

(#27) for accurate alignment with the door

glass.

Do not cover the holes that need to be

marked on the wall.

Failure to use these inserts when aligning

the U-Channel (For Door Glass) (#27) may

NOTE: Use a 1/4” thick wood or plastic shim to

fully press the U-Channel Bumper Inserts (#28)

into the U-Channel (For Door Glass) (#27)

DOOR

inside

29. Hold the U-Channel (For Door Glass) (#27) against the wall on the door side of the opening

to align it with the door glass and mark its position on the wall.

**Partially insert two of the U-Channel Bumper Inserts (#28) at the top and bottom and close the

door into the U-Channel (For Door Glass) (#27).

Mark the position of the U-Channel (For Door Glass) (#27) on the wall along the outside edge.

Open the door, hold the U-Channel (For Door Glass) (#27) in place on the wall and mark the holes

for drilling.

Remove the U-Channel (For Door Glass) (#27) and the U-Channel Bumper Inserts (#28).

Drill Ø5/16” anchor holes and insert the Wall Anchors (#16).

Apply a bead of silicone to the wall or to the back of the U-Channel (For Door Glass) (#27).

Install the U-Channel (For Door Glass) (#27) to the wall using the ST4.2 x 40mm Round Head

Screw (#17).

Use a 1/4” thick wooden or plastic shim to fully press the U-Channel Bumper Inserts (#28) into

the smaller holes in the U-Channel (For Door Glass) (#27) (Fig 29)