Installation Guide

3
ENIGMA SKY shower and tub door manual Ver 1 Rev 1 02/2018
©2018 DreamLine. All Rights Reserved
Roller Wheels tight leaving the
proper clearance beneath the
door glass and guide block
Bottom Roller Wheels
adjusted to make
contact with the Guide
Rail
Guide block screwed down
and square with glass
*Stopper properly
positioned and tight
-door makes contact
with stopper and
bottom bumper
evenly when the door
is in the fully open
position
*Stopper properly positioned and
tight so that the Door stops against
the stopper and seals rmly into the
bumper inserts in the u-channel
Guide Rail level
To secure the Stoppers (#05):
Apply the Thread Lock adhesive to the
threads of the set screws during the nal
installation. Fully tighten the set screws with
the supplied allen wrench.
Stopper
Thread Lock Adhesive
Recommend to apply thread lock to:
• Stopper set screws
• Wheel bolts
• Glass Bracket bolts
ENIGMA-SKY
troubleshooting and
maintenance tips
The Roller wheels can be
adjusted as needed so
that door glass makes
even contact within the
u-channel from top to
bottom
Guide Rail bracket ush with
wall and set screws tight;
Installation into a
stud strongly recommended
Glass brackets
tight
Panel Glass sits ush
on the threshold
All rubber gaskets and sleeves installed properly between
all hardware and glass to prevent glass to metal contact
Guide Rail
bracket ush
with wall
and set
screws tight
Bumper
inserts
installed into
u-channel
Inspect bottom
corners of door glass
for damage.
**Units with
damaged door glass
should not be used
until door glass has
been replaced**
Right Hand door installation shown as an example
Handle tight
* Stopper Locations as measured from the
wall to the center of the stopper:
• Panel side: 5” (+/-) when the door
contacts the bottom bumper
• Door side: 3-1/2” (+/-) (depends on
opening conditions)
Rotate disk to adjust
Door Glass
Panel Glass
SafeStop™
Bumper is
secured in
position with
3M tape or
screwed to
the wall