Installation Guide

12ENIGMA SKY shower and tub door manual Ver 1 01/2018

*NOTE: Installation of the Guide Rail

brackets into a stud or 2”x 6” wood

reinforcement is strongly recommended.

**NOTE: When installing to a stud,

drill a Ø1/4” hole and do not use

the anchors.

Fig 8

#06b

#06a

The guide rail wall

bracket should be

centered in the

bracket as shown

to allow for vertical

adjustment both

up and down.

Note that the bottom of the

bracket is thicker than the top

and must be installed correctly

(=)

Fig 7

Ø5/16"

Ø1/4" or

1 * 2

top

bottom

7. Hold the Guide Rail Bracket (#06) in the

marked position on the wall and mark the hole for

drilling through the Guide Rail Bracket (#06)

using a pencil (or center punch). (Fig 7)

8. Drill a Ø5/16” anchor hole and insert a Wall Anchor (#16). (**See note below)

Separate the Guide Rail Bracket (#06) components (#06a and #06b). Install the Guide Rail Wall

Bracket (#06b) to the wall using one ST4.2 x 55mm Countersunk Screw (#21). (Fig 8)