Installation Guide

18ENIGMA SKY shower and tub door manual Ver 1 01/2018

*NOTE: Installation of the Guide Rail

brackets into a stud or 2”x 6” wood

reinforcement is strongly recommended.

Do not use the Wall Anchor (#16) when

installing into a stud/wood).

#06b

#06a

Fig 19

2**

NOTE: Be careful not to scratch the upper rail while sliding the brackets onto the guide rail.

Fig 20

or Ø5/16"

Ø1/4"

**NOTE: When installing to a stud, drill a

Ø1/4” hole and do not use the anchors.

To lower the rail:

Loosen the top set

screw and tighten

the bottom set

screw.

To raise the rail:

Loosen the

bottom set screw

and tighten the

top set screw.

20. Re-attach the Guide Rail (#04) to the Stationary Panel Glass (#02) and attach the Guide Rail

Brackets (#06). (Fig 20)

19. Remove the Guide Rail (#04) from the Stationary Panel Glass (#02). Remove the Guide Rail

Bracket (#06) from the Guide Rail (#04) from the door end, hold it back in position on the wall and mark

the anchor hole. Drill a Ø5/16” hole. Separate the Guide Rail Bracket (#06) components (06a and 06b).

Attach the Guide Rail Wall Bracket (#06b) to the wall using one ST4.2 x 55mm Countersunk Screw

(#21). (Fig 19)