Installation Guide

23ENIGMA SKY shower and tub door manual Ver 1 01/2018

TIP: When using the screw method, use

caution to not crack the wall/tile and to

avoid any plumbing behind the wall.

NOTE:

The surfaces need to be clean and free of

construction debris before installing the bumper.

Wipe the area with an alcohol swab before

installation.

Inside

Ø5/16”

Wall

Inside

Wall

Inside

3M Tape

Wall

Fig 28

The

SafeStop™

Bumper (#26) is

reversible for Left

(as shown below

from inside the

shower) or Right

wall installation

A Phillips head Extender driver bit is

recommended for the screw installation

method

28. To install the

SafeStop™

Bumper (#26) with the screw method: Remove the PVC insert and

position the

SafeStop™

Bumper (#26) onto the threshold and against the u-channel on the stationary

panel side of the installation and mark the position of the hole on the wall. Drill a Ø5/16” hole and insert

the Anchor (#16). Remove the 3M Tape backing and position the

SafeStop™

Bumper (#26) onto the

threshold against the U-Channel (#01). Screw to the wall using the ST4.2 x 40 Countersunk screw and

re-insert the PVC insert. (Fig 28)