Manual

17FLEX Shower Enclosure manual Ver 3 Rev 3 03/2018
©2018 DreamLine. All Rights Reserved
NOTE: Measure to the edge of the door and
notch the Bottom Anti-water Strip (#08) with
a razor knife to fit around the magnetic strip,
leaving the flexible sweep intact.
Fig 11
Fig 12
1
2
3
1
2
3
Ø 1/8”
Inside
View
Outside View
Outside
View
RIGHT-HAND RETURN PANEL SHOWN AS AN EXAMPLE
inside
door
return panel
flexible sweep
12. Attach the Flanged Anti-water Strip (#07) to the
vertical edge of the Stationary panel glass.
Measure and cut the Bottom Anti-water Strip (#08)
to cover the bottom edge of the door from the pivot
to both sides of the Glass door. Attach both pieces of
the Bottom Anti-water Strip to the bottom edge of
the Glass door. (Fig 12)
11. Drill holes into the aluminum profile of the Door assembly (#02) through the predrilled holes in the
Corner Profile (#10) using an Ø 1/8 drill bit. Secure the Door assembly inside the Corner Profile (#10)
using the Pan Head Screws ST4.2×10 (#04) with the raised white washers. Cover the exposed screw
heads with the Decorative Covers (#06). (Fig 11)