Manual

Table Of Contents

NOTE:

Flip the entire assembly for opposite installation.

3. Move the Door assembly (02) with the

Wall profiles (01) onto the Shower base

with the Stationary glass side tight to the

wall. Adjust the Door assembly (02) by

stretching the top and bottom Expanding

rails evenly to extend the Door assembly

(02) tight to the opposite wall. If the top

and bottom wall opening measurements

are different or if the walls are out-of-

plumb, make adjustments by slightly

pulling the Wall profiles (01) out of the

Door assembly (02).

NOTICE:

The maximum adjustment width of the

Expanding rails is 3”. The wall profiles

allow for 1/2” adjustment for each side.

See Fig. 4 for details.

Fig. 3

Fig. 4