Manual

Table Of Contents

FLEX Shower Enclosure Panel manual Ver 3 Rev 5 072020

NOTE: Measure to the edge of the door and

notch the

Bottom Sweep vinyl (#08) with a

razor knife to fit around the magnetic strip,

leaving the flexible sweep intact.

Fig 11

Fig 12

Ø 1/8”

Outside View

RIGHT-HAND RETURN PANEL SHOWN AS AN EXAMPLE

inside

door

return panel

door

panel

door

inside

view

outside

view

12. Attach the Vinyl Seal with Flexible Fin (#07) to

the vertical edge of the Stationary panel glass.

Measure and cut the

Bottom Sweep vinyl (#08) to

cover the bottom edge of the door from the pivot to

both sides of the Glass door. Attach both pieces of the

Bottom Sweep vinyl to the bottom edge of the

Glass door. (Fig 12)

11. Drill holes into the aluminum profile of the Door assembly (#02) through the predrilled holes in the

Corner Profile (#10) using an Ø 1/8 drill bit. Secure the Door assembly inside the Corner Profile (#10)

using the

ST4.0 x 10 Pan head screw (#04) with the raised white washers. Cover the exposed screw

heads with the Decorative Covers (#06). (Fig 11)