Installation Guide

UNIDOOR PLUS (Style-J) manual Ver 1 Rev 7 102016
8
2. Please mark measurement lines on the wall and half
wall ledge for the Glass Door and U-channel
according to the size of your model.
You will need use the Product Width and Product
Height values determined in step #1 in Size Table B.
NOTE: M and L dimensions are from the finished
wall to the outside of the U-channel as shown in
Fig. 1.
NOTE: The Unidoor hinge is factory set to over close 8°.
The following procedure is recommended to ensure
proper alignment of the panel glass and door glass.
3. Align the Door so that it is perpendicular to the wall and
parallel to the threshold. Measure across the bottom span of
the Door and threshold on the outside of shower and
determine an equal value.
Use a straight edge as guide to mark a line on the half wall
ledge on the handle side for future reference.
See Fig. 2 for details.
L
I
L-1/16"
M
L
Door
Panel
Return Panel
M
M =
+
Door
Panel
-
1/8"
L =
Return Panel
+
7/16"
I =
Panel Height
72"
-
Fig. 1
Size Table A
Size Table B
outside
Door
Value
outside
inside
Fig. 2
2
1