Installation Guide

“UNIDOOR” Single Shower Door Ver.2 Rev.2 06/2016
16
4b. The hinges are factory set to 85 degrees.
You can change this angle by using the adjustment screws
on the hinge plate.
(Figure 5b)
4c. Use the supplied Allen Key to loosen the adjustment screws on the inside hinge plate, adjust
the door to the desired angle (90 degrees for example) then retighten the adjustment screws
(Figure 5c). Be sure that you create a tight seal with the supplied strike vinyl when the door is in
the closed position.
Figure 5b
Figure 5c
inside
outside
inside
outside
View from inside
of shower