Installation Guide

UNIDOOR PLUS (Style-J) manual Ver 1 Rev 7 102016

6. Slip the cut U-channel 2 (44”, bottom profile) (29)

and U-channel 1 (76”, wall profile) (09) onto the

Return panel glass (26) in the shown locations.

With the door open, place the Return panel glass on

the half wall ledge adjacent to the door and in line

with the wall mark. Adjust the Return panel glass

and U-channel 1 (wall profile) against the wall to

compensate for any out of plumb conditions

ensuring that the Return panel glass is level

vertically and the U-channel 1 is flush with the wall.

Mark the U-channel 2 (bottom profile) end

opposite of the wall at the exposed vertical glass

edge.

Remove the U-channel 2 (bottom profile). Leave

the U-channel 1 (wall profile) on the Return panel

glass. Set the Return panel glass aside.

Cut the U-channel 2 (bottom profile) 45° to the

mark (+) 1/2”. The end facing the wall will remain

straight.

Slip the U-channel 2 (bottom profile) back onto

the Return panel glass and set the Return panel

glass aside.

See Fig. 6 for details.

wall

Return

glass

U-channel 2

U-channel 1

inside

mark + 1/2"

45°

inside

Fig. 6

H (+) 1"

Fig. 5