Installation Guide

UNIDOOR PLUS (Style-J) manual Ver 1 Rev 7 102016

8. Slip the U-channel 2 (44”, bottom profile) (29)

onto the Stationary glass (11) and ensure that the

straight end of the U-channel 2 is flush with the

vertical glass edge.

Carefully butt the Stationary glass and Return panel

glass (26) together while on top of the half wall

ledge to form a tight corner from bottom to top. The

Stationary glass will be in front of the Return panel

glass.

While securely holding the two glass panels, attach

the 90° Corner Bracket (30) to the top corner.

Ensure that the 90° Corner Bracket is square and

gaskets are aligned properly before tightening the

glass holding screws.

Temporarily secure the bottom corner of the glass

panels with a generous strip of Painters tape.

Carefully butt the Return panel glass (26) up against

the wall vertically according to the M value stated in

Size Table B on page 5 and square it up with a level.

See Fig. 9 & 10 for details.

Return glass

Stationary glass

outside

inside

Return

glass

Stationary

glass

outside

inside

outside

Painters tape

inside

outside

Fig. 9

NOTE: Steps #8 and #9 involve careful

handling of the glass panels to

determine a custom fit measurement

unique to your installation. It is

essential that two installers be used

along with responsive communication

once the panels are temporarily fixed

together.

Fig. 10