Manual

Preparation

NOTE: DO NOT attach the handle to the door glass or the towel bar to the panel glass until

instructed.

DO NOT use the handle or towel bar to lift the glass during installation. This may result in

damage to the glass and/or serious injury. Always use an assistant or a professional grade

glass suction cup when handling heavy glass.

1. Prior to installation, examine all boxes and packages for shipping damage and compare the piece count

with the packing slip. After opening all boxes and packages read this introduction carefully. Check that all of

the necessary parts are included in the package by checking off the components on the “Detailed Diagram of

Shower Door Components”. If the unit has been damaged, has a finishing defect, or has missing parts, please

contact our customer support department within 3 business days of the delivery date. Please note that

DreamLine

will not replace any damaged products or missing parts free of charge after 3 business

days or if the product has been installed. Contact DreamLine

if you have any questions, and please

provide an order number, job name or other proof of purchase to help identify the original order.

2. Please note that you should consult your local building codes with questions on installation

compliance standards. Building and plumbing codes may vary by location, and DreamLine

is not

responsible for code compliance standards for your project and will not accept any returns.

3. If this unit is going to be installed in a new construction, please install all of the required plumbing and

drainage before installing the shower. Use a competent and licensed (if required by local code) plumber for

all plumbing installation

4. Make sure that prior to beginning the installation, the surfaces are leveled and solid and will be able to

support the total weight of the unit. Also make sure the walls are at right angles. Irregular installation surface

level, radius corners or improper angle of side walls will result in serious problems for your installation. Note

that some adjustments and drilling will be necessary during the installation process.

5. Protect all primary surfaces of the product during installation. Never set the glass down directly onto a tile

floor. Leave corner protectors in place until necessary to remove them. Always use a piece of wood or card-

board to protect the bottom edge and corners of the glass prior to and during installation.

6. This unit must be installed upon a finished threshold and against finished walls.

7. This model has 1/4” of adjustment for out-of-plumb wall conditions within the U-channels.

Verify that the walls are within this tolerance before proceeding with the installation.

8. This model requires that you drill into the threshold for proper installation. Contact the

manufacturer of the base or threshold material with any questions regarding the drilling of holes

into their product.

9. Threshold must be level for proper installation.

10. This model requires a minumum of 1-1/2” of flat, level threshold space for installation.

11. Professional installation recommended.

QUATRA PLUS Shower Enclosure Manual Ver 1 10/2018

Fix page

numbers from

here