Manual

Table Of Contents

UNIDOOR PLUS (STYLE I) manual Ver 1 Rev 6 10/2016

5. Slip the cut U-channel 2 (44”, bottom profile) (29)

and uncut U-channel 1 (76”, wall profile) (09) onto

the Return panel glass (26) in the shown locations.

Insert three to four 2” pieces of the Adjustment

spacer (#28) into the bottom u-channel (#29) as

necessary to level the panel glass. (Fig.5.1)

With the door open, place the Return panel glass on

the threshold adjacent to door and in line with the

wall mark. Adjust the Return panel glass and

U-channel 1 (wall profile) against the wall to

compensate for any out of plumb conditions

ensuring that the Return panel glass is level

vertically and U-channel 1 is flush with the wall.

Mark the U-channel 2 (bottom profile) end

opposite of the wall at the exposed vertical glass

edge.

Remove the U-channel 2 (bottom profile). Leave

the U-channel 1 (wall profile) on the Return panel

glass. Set the Return panel glass aside.

Cut the U-channel 2 (bottom profile) 45° to the

mark (+) 1/2”. The end facing the wall will remain

straight.

Slip the U-channel 2 (bottom profile)

back onto the Return panel glass and set

the Return panel glass aside.

See Fig. 5 for details.

6. Measure the actual width of your

Stationary glass (11) panel.

Use a miter saw to cut the second U-

channel 2 (44”, bottom profile) (29) 45°

to the actual width of the glass (+) 1/16”.

See Fig. 6 & 7 for details.

wall

inside

Return

glass

U-channel 2

U-channel 1

inside

mark + 1/2"

45°

inside

Fig. 5

Fig. 6