Manual

Table Of Contents

UNIDOOR Single Shower Door manual Ver 2 Rev 6 02/2018

ATTENTION:

As viewed from inside the shower, the hinge

plate is very close to the drilled holes in the wall

and might get scratched while installing the long

screws. Be careful not to scratch the hinge

surfaces during installation.

(OPTIONAL)

5. Carefully remove the hinge plates from the Hinges

(05) (Fig 5.1), remove the Door Glass (01) and

carefully set it aside.

Install the remaining Countersunk screws ST5 x 70

(04) into the wall, place the Door Glass (01) (with

the 5/8” bottom spacers still attached) back into

position onto the Hinges (05) and re-assemble the

Hinges (05). Once the door glass is secure, remove

the 5/8” spacers from beneath the Door Glass (01).

(Fig 5)

Fig. 5

Fig. 4

TIP: The PVC hinge spacer can

also be used as a template to

assist with marking the hinge

mounting holes.

inside

*Only use the PVC hinge spacer to

correct for minor out-of-plumb

wall conditions.