Manual

©2018 DreamLine. All Rights Reserved
UNIDOOR Single Shower Door manual Ver 2 Rev 6 02/2018
20
8. Take three measurements:
 from the top edge of the Door Glass (01) to the
upper body of the top Hinge (05) (+) 7/8”
 from the lower body of the upper Hinge to the
upper body of the bottom Hinge (+) 1-3/4”
 from the lower body of the bottom Hinge to top
of the installed Bottom anti-water strip (07)
(+) 1-7/8”
Cut the Side strip (06) according to the
measurements.
Notch the cut strips to be able to slide them into
the Hinge and around the sweep vinyl to cover the
space to the wall.
Press the cut strips onto the vertical edge of the
Door Glass.
(Fig 8)
ATTENTION; Prior to the next step, please be sure that the
section of the wall where you need to attach the L-shaped strip
(08) is clean, dry and free from soap, oil and any construction
debris.
9. Hold the door in the closed position, parallel to the threshold. Place
the *L-shaped strip (08) onto the door edge. Make sure that the
door glass makes good contact with the entire length of the
L-shaped strip (08), and mark its location on the wall.
Open the door. Remove the tape backing from the adhesive strip
and firmly press the L-shaped strip (08) to the wall.
Allow 24 hours for the adhesive to fully setup before use.
(Fig 9 and Fig 10)
*NOTE:
The above procedure for installing the L-shaped strip (08) is for
the Unidoor Style A single shower door installation only. When
installing another model with additional panel glass, please
refer to the separate panel installation manual located in the
glass packaging for model specific instructions. The vinyl seals
that apply to the panel glass are packaged with the panel glass.
1 2
4
6
3
Into the hinge
Into the hinge
Into the hinge
7/8"
7/8"
7/8"
5
Into the hinge
Around sweep vinyl
1"
7/8"
1
2
Fig. 9
inside
Fig. 8
Allow the adhesive to set up
for 24hrs after installation
door