Manual

Table Of Contents

UNIDOOR Single Shower Door manual Ver 2 Rev 6 02/2018

Preparation

1. Prior to installation, examine all boxes and packages for shipping damage and compare the piece

count with your packing slip. After opening all boxes and packages read this introduction carefully.

Check that all of the necessary parts are included in the package(s) by checking off the

components on the “Detailed Diagram of Shower Door Components”. If the unit has been

damaged, has a finishing defect, or is missing parts, please contact our customer support

department within 3 business days of the delivery date. Please note that DreamLine

will not

replace any damaged products or missing parts free of charge after 3 business days or if the

product has been installed. Please contact DreamLine

if you have any questions and please

provide an order number, job name or other proof of purchase to help identify the original order.

2. Please note that you should consult your local building codes with questions about

installation compliance standards. Building and plumbing codes may vary by location, and

DreamLine

is not responsible for code compliance standards for your project and will not

accept any returns.

3. If this unit is going to be installed in a new construction, install all of the required plumbing and

drainage before installing the shower. Use a competent and licensed (if required by local code)

plumber for all plumbing installation.

4. Make sure that prior to beginning the installation, the surfaces are leveled and solid and will be

able to support the total weight of the unit. Also make sure the walls are at right angles. Irregular

installation surface level, radius corners or improper angle of side walls will result in serious

problems for your installation. Please note that some adjustments and drilling will be necessary

during the installation process.

5. Protect all primary surfaces of the product during installation. Never set glass down directly onto

a hard surface unless instructed. Leave corner protectors in place until necessary to remove them.

Always use a piece of wood or cardboard to protect the bottom edge and corners of the glass

prior to and during installation to prevent damage.

6. This unit must be installed upon a level finished threshold and against plumb finished walls.

7. This door is extremely heavy and the hinges on this door must be attached into studs or to

preinstalled 2” × 6” wood reinforcement behind the wall. See pages 9, 10 & 11 for details.

8. The single Unidoor installation does NOT have any adjustment for out-of-plumb or out-of-level

conditions. Please verify that the walls are plumb and the threshold is level before proceeding

with the installation.

9. Professional installation is recommended for this heavy glass frameless shower door.

NOTE: DO NOT attach the handle to the door glass until instructed.

DO NOT use the handle to lift the glass during installation. This may result in damage to

the glass and/or serious injury. Always use an assistant and/or a professional grade glass

suction cup when handling heavy glass panels.