Manual

13ENIGMA-XO Shower Enclosure manual Ver 1 Rev 1 01/2018

Door end of guide rail

High spot of disk bushing

*NOTE: The outer glass bracket disk has

an eccentric bushing for adjustment.

Be sure to install both glass bracket disks

with the high spot of the bushing pointed

towards the door end of the guide rail.

TIP: Mark the location of the high spot on the outer

surface of the adjustment disk with an erasable felt

tip pen to make adjustment easier to see.

glass bracket

disk

Fig 8

outside

stopper hole

thread lock

outside

panel end

not used in this

configuration

see step# 9

Door end

of Guide

Rail

outside

8a. Attach the Upper Guide Rail (#03) to the Stationary Glass (#02) with the Glass Brackets (#07) and

tighten the bolts into the predrilled holes in the Upper Guide Rail (#03). Make sure both adjustment

disks are installed in the same direction with the high spot towards the door end. (see *Note below)

Make sure that the guide rail is attached parallel to the top edge of the stationary panel glass. (Fig 8.3)

8b. Slide the Door Stoppers (#01) onto each end of the Upper Guide Rail (#03) and secure them

using the 4mm Allen Wrench (#11). Install the panel-end stopper into the pre-drilled stopper

hole in the Upper Guide Rail (#03) and apply Thread Lock (#26) to the set screw. Attach the

door-end stopper approximately 4” from the other end of the guide rail. (The door-end stopper

position will be adjusted in a later step after the door glass is installed). (Fig 8)

8c. Slide the Guide Rail Brackets (#08) onto each end of the Upper Guide Rail (#03) and secure them.

Next, assemble the Wall Bracket (#19) onto the bottom corner of the Stationary Glass (#02) with the

bolt facing into the shower as shown in Fig 8.5. Use the supplied gaskets to protect the glass. (Fig 8)