Manual

21ENIGMA-XO Shower Enclosure manual Ver 1 Rev 1 01/2018

To lower the rail using the

Guide Rail Bracket:

Loosen the top set screw and

tighten the bottom set screw.

To raise the rail:

Loosen the bottom set screw

and tighten the top set screw.

Fig 22

Fig 20

outside

Fig 21

Panel end

Door end

Glass bracket

Guide Rail Bracket

or Glass Connector

(Right hand door installation shown as example)

To raise or lower the rail

using the Glass Connector:

Loosen the bolt and rotate

the disk then tighten the

bolt.

NOTE: Use the Guide Rail Bracket (#08) set

screws and/or the Glass Connector (#28) to

adjust the Guide Rail (#03) to level.

TIP: Adjust the installed Upper Guide Rail (#03) to level

as necessary using the Guide Rail Brackets (#08) first

and then the Glass Brackets (#07). Start adjustments

from the door end. (Fig 21 and Fig 22)

20. Reposition the Stationary Glass (#02) and Upper Guide

Rail (#03) onto the threshold and fasten the sleeves of the

Guide Rail Brackets (#08) to the installed bracket on the wall

and the Glass Connector (#28).

Tighten the set screws on the Guide Rail Brackets (#08) to

secure the Upper Guide Rail (#03). Position the bracket set

screws so that they are accessible from the top and bottom.

(Fig 20.1 and Fig 20.2)

Assemble the Wall Bracket (#19) at the bottom corner of the

Stationary Glass (#02). Use the clear vinyl gasket between

the glass and the metal parts to avoid contact with the glass,

then tighten the bolt with the supplied allen wrench. (Fig 20)