Manual

25ENIGMA-XO Shower Enclosure manual Ver 1 Rev 1 01/2018

Note: The adjustment disks in

the wheels are the same as the

disks in the Glass brackets and

can be rotated to adjust the

door glass to create a seal with

the wall. See detailed

description on page 32.

TIP: Use a 3/16” shim

beneath the door glass when

adjusting the level of the

door so that the glass does

not make contact with the

guide block.

TIP: Mark the location of the

high spot on the outer surface of the

adjustment disk with a felt tip pen to

make adjustment easier to see.

Roller wheel adjustment disks

Raise glassLower glass

Fig 29

outside

safety set screw

inside

safety set screw

add threadlock to

the safety set screw

and wheel bolt

NOTE: DO NOT attach the handle to the door glass until instructed to do so.

DO NOT attempt to lift the door glass with the handle as this may result in damage to the glass

and/or serious personal injury.

27. Attach the two Rollers (#04) to the Door Glass (#05) with the wheels facing the outside of the

shower. Align the safety set screw towards the top for easier access (See Fig 29 and page 30 for

details).

Lift the door and position the Rollers (#04) onto the Upper Guide Rail (#03) while carefully sliding

the bottom edge of the Door Glass (#05) into the groove of the Guide Block (#12).

If necessary, adjust the disks on both Rollers (#04) to ensure that the bottom edge of the Door Glass

(#05) does not touch the Guide Block (#12) and the bulb vinyl seal meets evenly with the wall.

(see details on page 32). (Fig 29)