Manual

NOTE: To maximize the life of your door, it is important to regularly inspect

the glass and other hardware for misalignment, proper attachment, and/or

damage. Contact DreamLine

with any questions or concerns.

Product Maintenance

BASES and BACKWALLS: To ensure long lasting life for your acrylic back walls: wipe them off

after each use with a soft cloth. To clean the acrylic back walls use non-abrasive sprays or cream

based cleaners. Avoid the use of aerosol spray cleaners. Never use abrasive cleansers, metal

brushes or scrapers that could scratch or dull the surface.

GLASS: To ensure long lasting life for your glass shower products: wipe them off after each use

with a soft cloth. Rinse and wipe off the glass using either a soft cloth or a squeegee to prevent

soap buildup and water spots (Hard water can etch the surface of the glass over time if left to

dry). To prevent scratching the surface: never use abrasive cleaners or cleaning products that

contain scouring agents. Never use bristle brushes or abrasive sponges that may scratch the

surface.

HARDWARE: To ensure a long lasting finish: wipe off the metal parts after each use with a soft

cloth. Do not use abrasive cleaners or cleaning products containing ammonia, bleach or acid. If

accidentally used, rinse the surface as soon as possible to prevent damage to the finish (peeling

or corrosion). After cleaning the polished finishes, rinse thoroughly and wipe dry with soft cloth.

Clean stainless steel surfaces at least once a week. When applying stainless steel cleaner or

polish to stainless steel hardware, work with (not across) the grain. Never use an abrasive

sponge or cloth, steel wool or wired brush as these may permanently scratch the surfaces.

Enigma-XO Maintenance checklist

◻ Guide rail level and tight

◻ Guide rail brackets tight to the walls

o All set screws tight

◻ Inline and Return Panel glass secure

◻ Panel glass brackets tight

◻ Guide block square to the threshold and glass

◻ Proper clearance beneath the door glass between the threshold and within the guide block

◻ Door Glass adjusted so that the Bulb vinyl seal makes even contact with the return panel glass

◻ Wheel assemblies tight

o Wheel roller bolts tight on all four wheels

o Wheel assembly safety set screws tight and accessible on all four wheels

◻ Stoppers tight and positioned correctly

o Panel-side stopper installed into the pre-drilled hole in the guide rail

o Adequate Handle clearance when the door is fully open

o Door-side stopper positioned at approximately 3” (+/- 1/8”) (as measured from the

return panel glass to the center of the stopper)

◻ Stopper stops the door and bulb vinyl seals to the return panel glass

◻ SafeStop bumper secure to the wall

◻ Remove vinyl seals to inspect the edges of the door glass for concealed damage

o Damaged glass must be replaced!

◻ Replace damaged or missing vinyl seals

33ENIGMA-XO Shower Enclosure manual Ver 1 Rev 1 01/2018