Manual

19ENIGMA-XO Shower Enclosure manual Ver 1 Rev 1 01/2018
©2018 DreamLine. All Rights Reserved
Fig 18
Part#12 - Guide Block (with caps)
2
*see
note
1
use a pencil or
a center-punch
to mark the hole
3
**only use anchor
with tile threshold
4
5
overhead view of threshold & guide block
Guide Block must be installed
square to the plane of the glass
M5 X 10
ST4.2 X 40
18. To install the Guide Block (#12): Loosen the set screw and remove the guide block face plate.
Apply silicone to the underside of the Guide Block (#12) and screw the Guide Block (#12) to the
threshold as described below:
*NOTE:
◾For installation into an Acrylic Threshold:
drill an Ø1/8”(3mm) hole and use the ST4.2 x 40mm Countersunk Screw (#17)
OR
◾For installation into a Tile Threshold:
drill a Ø5/16”(8mm) hole, install Wall Anchor Ø5/16” (#09b) and use the ST4.2 x 40mm
Countersunk Screw (#17)
The Guide Block (#12) must be screwed down to the threshold. (Fig 18)