Manual

30ENIGMA-XO Shower Enclosure manual Ver 1 Rev 1 01/2018

3M TAPE

1 2

3 4

Fig 35

Extender driver bit recommended

for screw installation method

The Bumper (#30) is reversible for

Left or Right wall installation.

(Left wall installation shown below from

inside the shower)

Inside

Door

Panel

NOTE: Use caution if using the screw

method to not crack the wall/tile and to

avoid any plumbing behind the wall.

NOTE:

The surfaces need to be clean and free of

construction debris before installing the bumper.

Wipe the area with an alcohol swab before installation

32. To install the Bumper (#30) with the screw method: position the Bumper (#30) onto the threshold

and against the wall on the stationary panel side of the installation. (For 72” model, this will be the side

of the opening with the large stationary panel). and mark the position of the hole onto the wall. Drill a

Ø5/16” hole and insert the wall anchor. Remove the 3M Tape and position the Bumper (#30) onto the

threshold against the Wall Bracket (#19) and attach using the ST4.2 x 40 Countersunk screw.

(Fig 35)