Manual

2ENIGMA-XO Shower Enclosure manual Ver 1 Rev 1 01/2018
©2018 DreamLine. All Rights Reserved
A
Guide Rail Brackets must be firmly
attached to the wall. Installation into a
stud is strongly recommended.
All of the guide rail bracket set
screws must be tightened.
B
Thread Lock must be applied to both
stopper set screws.
Panel-side stopper must be installed
into the pre-drilled stopper hole in
the upper guide rail.
Door-side stopper must be installed
at the proper position to stop the
door from contacting the wall.
E
Bumper Vinyl Seal must be installed on
the closing edge of the door glass
D
Lower Roller wheels must be adjusted
during installation to make contact with
the Upper Guide Rail. Tighten Safety set
screws. Apply thread lock.
F
The Guide Block must be screwed to the
threshold and installed square to the
panel glass and door glass. Installing the
guide block crooked may damage the
bottom edge of the door glass and lead to
breakage.
C
Roller Wheel Safety Set Screws must
be re-tightened after installation.
Apply thread lock.
A
B
D
F
G
E
C
B
A
DOOR
PANEL
Right hand door installation shown as an example
PLEASE READ THE ENCLOSED INSTALLATION
MANUAL FOR DETAILS REGARDING PROPER
INSTALLATION.
THE LATEST VERSION OF THE INSTALLATION
MANUAL IS AVAILABLE TO VIEW OR PRINT
ON DREAMLINE.COM
!
IMPORTANT INFORMATION
REGARDING THE INSTALLATION
OF THIS SHOWER DOOR
G
Bumper is secured in position with 3M
tape or screwed to the wall.