Manual

10CORNERVIEW/FRENCH CORNER Shower Enclosure Manual Ver 4 Rev 1a 05/2021

washer

screw

decorative cap

adjust (if necessary)

NOTE: Do not drill the

profiles throughout, only

through the first layer.

Fig 6

Ø1/8”

3 4

1/2”

6. If necessary, adjust the position of the Roller Wheels (#11) within the slot(s) in the top and bottom

rails of the Door Glass Assemblies (#03). (Fig 6.1)

Perform any final adjustments of the assembled unit within the Wall Profiles (#01) and make certain

that the bottom rails are tight to the threshold.

From inside the shower, drill holes into the first layer of the Wall Profile and the Glass Profile (Fig 6.2)

using an Ø1/8” drill bit.

Secure the Glass Profile to the Wall Profile (#01) using the Pan Head Screws ST4.2×10 (#07) and

Washers (#08) and cover the exposed screws and washers with the Decorative Covers (#08).

(Fig 6)