Folding Shower Seat Manual

Folding Seat Installation Manual
Thank you for choosing our product, please read the installation manual before starting
the work.
Important
Please read carefully the following instructions before installing your shower door. If you
have any questions on this shower door installation - please call our technical support
specialists Monday to Friday 9:00AM – 5:00PM EST at 1-866-731-8378 Option 3 or e-mail
our technical support group at [e-mail]
Attention:
This shower seat MUST NOT be mounted to sheetrock, drywall, plaster, fiberglass, acrylic or
other similar wall surfaces without appropriate wood or steel backing support material.
Max capacity: 250 Lbs when installing to the wall through the studs
Additional wall support is required:
Installation of the wall mounted folding shower seat requires additional wood framing in a place of
installation. We recommend 2” x 12” or 2 (two) 2” x 6” wood blocking continuously installed between
the studs. Lower edge of the wooden block should be 13” from the top of the seat. You may need to
remove a portion of the sheetrock with tiles to install the wooden block. If you have an access from the
back it will be easier to cut a piece of sheetrock to install this additional wood framing.
Packing list:
Number Name of components Quantity
1 Seat components set 1
2 Bracket sliding slot 1
3 5x70mm screw 10
4 Installation manual 1
1