User Manual

“INFINITY-Z” Rev.2 Ver.4 08/2013

9. Move the finished frame to the designated position on

the shower base, the bathtub or the threshold

(depending on your installation); push it against the

walls. If your top and bottom wall opening

measurements are different or if the walls are out-of-

plumb, make adjustment by slightly pulling the Wall

profiles out of the Glass Profiles.

Use the level to adjust the frame in the vertical position

See Fig. 9 for details.

Fig. 9

10. Using help to hold this assembly in the right position,

mark the drill holes on the wall through the holes on

the flange of the Wall Profile.

Gently set the assembled unit aside; drill the holes

using Ø 5/16” drill bit and insert the Wall anchors

(14).

Apply silicone along the wall profile and around the

holes on the wall. Also apply silicone caulk under the

bottom Guide rail (03). Place the whole shower

assembly back in the designated position and secure

it to the walls using the Round head screws

ST4.2×30 (9).

See Fig. 10 for details.

Fig. 10

Ø 5/16”