Owner Manual

Installation steps

INFINITY-Z manual Ver 4 Rev 5 06/2017 6

TIP: For easier installation into the opening, cut off an extra 1/4”:

FINISHED OPENING (W) - 3-5/8”= FINISHED CUT LENGTH “D”

Fig 1

Fig 2

Fig 3

Bottom

Middle

Top

Panel end

Door end

FINISHED OPENING - 3-3/8"=FINISHED CUT LENGTH “D”

NOTE: The Top and Bottom Guide Rails (#03)

are shorter than the model size by design. They

have been precut for your model width and are

made to fit between the wall profiles, (not wall to

wall). See the table below:

48” (for shower) 44-5/8”

54” (for shower) 50-5/8”

60” (for shower) 56-5/8”

60” (for tub) 56-5/8”

Model Size

Precut

Rail Length

2. Subtract 3-3/8” from your finished opening (W) to

determine the finished cut length for the Top and

Bottom Guide Rails (#03). Cut the Top and Bottom

Guide Rails (#03) to the finished cut length “D”.

Cut from the door end only, (which is the end farthest

from the glass holder hole) and cut each rail to the same

length from the same end. (Fig 2 and Fig 3)

1. Measure the distance between the two finished

walls at the top (at model height: 58” or 72”), middle

and bottom. The wall profiles will adjust for

out-of-plumb conditions, so use the smallest

measurement as the “finished opening”

dimension to determine the finished cut length in

Step #2. (Fig 1)