Instruction Manual

ManualsBrandsDreams ManualsFurnitureAngel Bedstead

construction of this unit. These loose items should be kept

*Only supplied if upgraded sprung system chosen

ANGEL BEDSTEAD

Parts Identification

PLEASE READ

this sheet prior to assembly to familiarise

yourself with the various stages of construction. Carefully

open the pack supplied and check the contents against the

parts and fittings check list.

Do not destroy any of the packaging until you are certain

that you have all the necessary parts for the assembly.

Please ensure that the packaging is disposed of in a

safe environmentally friendly way.

CAUTION: There are small components used in the

away from young children whilst assembling your unit to

avoid the danger of choking hazards.

Qty

Headboard

Footboard

Leg

Right Side Rail

Wooden Slats

Metal Sprung Slat System*

1 Set

1 Frame

Parts Checklist

Ref. Description

Note:

Standard wooden slat frame (part 6)

Upgraded sprung slat frame (part 7)

Page 1 of 4

5 Left Side Rail 1

Summary of content (4 pages)

PAGE 1
ANGEL BEDSTEAD PLEASE READ this sheet prior to assembly to familiarise yourself with the various stages of construction. Carefully open the pack supplied and check the contents against the parts and fittings check list. Do not destroy any of the packaging until you are certain that you have all the necessary parts for the assembly. Please ensure that the packaging is disposed of in a safe environmentally friendly way. CAUTION: There are small components used in the construction of this unit.
PAGE 2
Fittings Checklist Code A B C Description Qty Bolt (M8x30mm) x8 Spring Washer Washer (22x8mm) Code Description Qty F Sleeve Nut (M6x1mm) x6 G Flat Washer (6mm) x6 H Allen Key (4mm) x1 I Bolt (M8x75mm) x12 x12 D Allen Key (5mm) x1 E Bolt (M6x40mm) x6 x4 Note: The following fittings will be found in the box which contains the Sprung Slat Frame. They are not in the main hardware pack, of the bed itself.
PAGE 3
Bed Assembly Stage 1 1 3 1 2 & 2 Fix legs (3) in the marked positions, on underside of headboard (1) and footboard (2) . Stage x12 B x8 A 2 x12A C x4 I 1 4 1 5 I B C 4 CB A 2 1 2 10mm 4 5 2 5 2 CB A 5 Fit the bolts (I), spring washers (B) , and flat washers (C) through side rails (4 & 5) to the holes in the headboard (1) (N.B. at the last step, you must tighten these bolts very tightly). Fit the bolts (A), spring washers (B) , and flat washers.
PAGE 4
Bed Assembly Stage G x6 E BED SLAT FIXING 2 x6 x6 F Lay the set of slats (6) onto the slat support rails on the side rails. 6 Align the first and last slat with the end of the rails, and secure in place using the bolts (E), washers (G) and sleeve nuts (F). Fully tighten using the allen key (H). 6 6 Use all of the x6 sets provided (E, F & G). Once secure fix the centre slat using the bolts as before.