Manual

ManualsBrandsDreams ManualsFurnitureLatina Bedstead

1 of 5

LATINA BED

Assembly Instructions

NOTE: It will require two people to assemble this bed. Assembly should be carried out in the room that

the bed will be used in.

1. We suggest you spend a short time reading through this leaflet and then

follow the simple step by step instructions.

2. Do not discard any of the packaging until you have checked that you

have all the parts and the pack of fittings.

3. To ensure an easier assembly, we strongly advise that all fittings are only

finger tightened during initial assembly. Only upon completion of the

assembly should all fixing points be fully tightened.

4. We recommend a periodic check on all fixing points to make sure they remain

fully tightened.

5. Keep glue and fittings out of children’s reach.

In the unlikely event that this product has missing or damaged parts,please

call 08442 920000 to obtain spares.

spare

Before you

start, here

is some

helpful advice

Minimum No. of people



recommended to assemble

this product:

Approx assembly time:



Summary of content (5 pages)

PAGE 1
LATINA BED Assembly Instructions  Minimum No. of people recommended to assemble this product: Approx assembly time:  NOTE: It will require two people to assemble this bed. Assembly should be carried out in the room that the bed will be used in. Before you start, here is some helpful advice 1. We suggest you spend a short time reading through this leaflet and then follow the simple step by step instructions. 2.
PAGE 2
Component parts and fittings contained in the box PARTS Fittings A M6 x35mm Bolt 6pcs B M6 JCN Nut 6pcs C 1 piece 4MM Allen key 1pc 5MM Allen key 1pc D E Spanner 1pc F 40mm Screw 2 pieces 8pcs 1 piece 2 pieces 2 of 5
PAGE 3
ASSEMBLY 1) Tighten the foot (4) to footboard (2) as STEP 1 shown. 1) Attach Side Rail (3) to Headboard (1) and Footboard (2) by pushing the bracket down STEP 2 to fit it.
PAGE 4
ASSEMBLY NOTE: Slats not supplied shown for reference only. Both slats on “step 3---step 6” can be assembled to the bedstead. You can make a choice between the two slats. STEP 3 1) Support leg height have the four position, you can adjust according to the bed 1 ○ 2 ○ 3 ○ 4 ○ height to choose the right position to fix in the “STEP 3”. Select correct height for your bedstead 2) If need, you can adjust by screwing in or out the support leg leveler at the bottom. 1) Bolt the legs onto the slats frame.
PAGE 5
ASSEMBLY Solid Slat System: STEP 6 1) Carefully place the slat frame onto the bed. 2）Use bolt (A) and JCN nut (B) to fix the Slat frame onto the bed.