Safety data sheet

ManualsBrandsDREMEL ManualsDrillsGlass drill bit 3.2 mm 662 Cylinder shank 1 pc(s)

MATERIAL SAFETY DATA SHEET

Copper Harbor Company, Inc. Page 1 of 8

Date Prepared: 07/21/10

Date Printed: 3/28/11

MSDS No.: 0252-09

Product: G.A.L.CUTTING OIL

** Dremel PN 2610008485

1. CHEMICAL PRODUCT AND COMPANY IDENTIFICATION

Material Identity

Product Name: G.A.L. CUTTING OIL

Product Code:

General or Generic ID:

Company Emergency Telephone Number:

Copper Harbor Company, Inc. 1-800-451-8346

2300 Davis Street

San Leandro, CA 94577-2204

510-639-4670

2. COMPOSITION / INFORMATION ON INGREDIENTS

Material CAS# % by Weight

Water 7732-18-5 94-97

Ethylene Glycol 107-21-1 3 – 4.9

Diethylene Glycol 111-46-6 0 – 1.5

Dipotassium Phosphate 7758-11-4 0 – 0.5

Other n/a 0-1.1

This chemical is subject to the reporting requirements of Section 313 of SARA Title 110.

3. HAZARDS IDENTIFICATION

Potential Health Effects

Eye: Data N/A

Skin:

Effect on lungs and kidneys.

Swallowing:

Effect on lungs thorax or respiration.

Inhalation:

Pulmonary edema.

Summary of content (8 pages)

PAGE 1
MATERIAL SAFETY DATA SHEET Copper Harbor Company, Inc. Product: 1. Page 1 of 8 Date Prepared: 07/21/10 Date Printed: 3/28/11 MSDS No.: 0252-09 G.A.L.CUTTING OIL ** Dremel PN 2610008485 CHEMICAL PRODUCT AND COMPANY IDENTIFICATION Material Identity Product Name: G.A.L. CUTTING OIL Product Code: General or Generic ID: Company Copper Harbor Company, Inc. 2300 Davis Street San Leandro, CA 94577-2204 510-639-4670 2.
PAGE 2
MATERIAL SAFETY DATA SHEET Copper Harbor Company, Inc. Product: Page 2 of 8 Date Prepared: 07/21/10 Date Printed: 3/28/11 MSDS No.: 0252-09 G.A.L.CUTTING OIL ** Dremel PN 2610008485 Medical Conditions Generally Aggravated By Exposure: Pre-existing lung conditions. Pre-existing urinary conditions. 4. FIRST AID MEASURES Inhalation: If respiratory symptoms or other symptoms develop, move victim away from source of exposure and into fresh air. If symptoms persist, seek immediate medical attention.
PAGE 3
MATERIAL SAFETY DATA SHEET Copper Harbor Company, Inc. Product: Page 3 of 8 Date Prepared: 07/21/10 Date Printed: 3/28/11 MSDS No.: 0252-09 G.A.L.CUTTING OIL ** Dremel PN 2610008485 Spill Response Procedures: Combustible, keep all sources of ignition away from spill. Stay upwind and away from spill. Isolate hazard area and limit entry to authorized personnel. Stop spill if it can be done without risk. Wear appropriate protective equipment including respiratory protection as conditions warrant.
PAGE 4
MATERIAL SAFETY DATA SHEET Copper Harbor Company, Inc. Product: Page 4 of 8 Date Prepared: 07/21/10 Date Printed: 3/28/11 MSDS No.: 0252-09 G.A.L.CUTTING OIL ** Dremel PN 2610008485 Work/Hygienic Practices: See Section 7 9. PHYSICAL AND CHEMICAL PROPERTIES Appearance: Light Green Liquid Boiling Point: Not Available Specific Gravity:
PAGE 5
MATERIAL SAFETY DATA SHEET Copper Harbor Company, Inc. Product: Page 5 of 8 Date Prepared: 07/21/10 Date Printed: 3/28/11 MSDS No.: 0252-09 G.A.L.CUTTING OIL ** Dremel PN 2610008485 12. ECOLOGICAL INFORMATION ENVIRONMENTAL FATE Movement & Partitioning: Bioconcentration potential is low (BCF less than 100 or Log Kow less than 3). Log octanol/water partition coefficient (log Kow) is -1.36. Henry's Law Constant (H) is 6.0E-08 atm-m3/mol. Bioconcentration factor (BCF) is 10 in golden orfe.
PAGE 6
MATERIAL SAFETY DATA SHEET Copper Harbor Company, Inc. Product: Page 6 of 8 Date Prepared: 07/21/10 Date Printed: 3/28/11 MSDS No.: 0252-09 G.A.L.CUTTING OIL ** Dremel PN 2610008485 14. DOT SHIPPING NAME NON-REGULATED 15. OTHER INFORMATION THIS PRODUCT CONTAINS COMPONENT(S) CITED ON THE FOLLOWING REGULATIONS.
PAGE 7
MATERIAL SAFETY DATA SHEET Copper Harbor Company, Inc. Product: Page 7 of 8 Date Prepared: 07/21/10 Date Printed: 3/28/11 MSDS No.: 0252-09 G.A.L.CUTTING OIL ** Dremel PN 2610008485 WHMIS Information: D2A - material has potential toxic effects. Refer elsewhere in the MSDS for specific warnings and safe handling information. Refer to the employer's workplace education program.
PAGE 8
MATERIAL SAFETY DATA SHEET Copper Harbor Company, Inc. Product: Page 8 of 8 Date Prepared: 07/21/10 Date Printed: 3/28/11 MSDS No.: 0252-09 G.A.L.