User Manual
(4000/4250/4300)
(4300)
(4300)
*) not standard included
LIGHT MODULE
I & II
(4300)
8
I
This product contains a lithium button/coin cell
battery. If a new or used lithium button/coin cell
battery is swallowed or enters the body, it can cause
severe internal burns and can lead to death in as little
as 2 hours. Always completely secure the battery
compartment. If the battery compartment does not
close securely, stop using the product, remove the
batteries, and keep it away from children. If you think
batteries might have been swallowed or placed inside
any part of the body, seek immediate medical attention.
INITIAL SET-UP
placement of the batteries and to check that all of the tab
CHANGING BATTERIES
Do not pull the screw out
completely.
making sure to replicate the orientation of the original
When reassembling make sure that the switch and the
slider are both in the same ON (I) or OFF (O) position.
This way the switch will match the ‘fork’ of the slider. (I)
INSTALLATION AND USE
The light module
will only work with the new style nose cap R that came
with the tool.
– I
– II
ACCESSORIES
ALWAYS UNPLUG THE TOOL BEFORE CHANGING
ACCESSORIES
Use only Dremel tested, high performance accessories.
Be sure to read the instructions supplied with your
Dremel accessory for further information on its use.
Handle and store accessories carefully to avoid
chipping and cracking.
CHANGING ACCESSORIES
9
Collet nut
Shaft lock button
Wrench
*) not standard included
Do not engage
the shaft lock while the tool is running.
EZ TWIST INTEGRATED WRENCH
Aq
Do not engage the
shaft lock while the tool is running.
DREMEL CHUCK 4486 (4300)
Do not engage the
shaft lock while the tool is running.
HELPFUL TIPS WHEN USING THE DREMEL CHUCK
• The Dremel chuck and the collet and collet nut system
more precise accessory holding solution especially in
•
•
22