User manual

4. With the shaft lock engaged twist nose cap clockwise
to tighten the collet nut.
5. Screw the nose cap back into its original position.
NOTE: Be sure to read the instructions supplied with
your Dremel accessory for further information on its
use.

BALANCING ACCESSORIES



slightly loosen collet nut and give the accessory or collet
a 1/4 turn. Re tighten collet nut and run the Rotary Tool.

accessory is running in balance. Continue adjusting in this
fashion until best balance is achieved.
USING ATTACHMENTS

that expand the functionality of your tool.
NOTE
Not all attachments listed below are included in your kit.
Use only Dremel tested, high performance attachments!
You can order attachments through the Dremel Service
Center or go to www.dremel.com for attachment and
accessory compatibility.
1. 

NOTE
For optimum performance allow your new Flexshaft to
run at high speed on your multitool in a vertical position
for 2 minutes before use.
2. 
grind at perfect 90 and 45 degree angles.

3. 

4. 


5. 


6. 

7. 
accessories in right angle for hard to reach places.

8. 

GETTING STARTED
USE




Always hold the tool away from your face. Accessories
can be damaged during handling and can y apart as they
come up to speed.
When holding tool, do not cover the ventilation openings
with your hand. Blocking the ventilation openings could
cause the motor to overheat.




to do the work for you. Do not put pressure on the

accessory lightly to the work surface and allow it to touch
the point at which you want to begin. Concentrate on
guiding the tool over the work using very little pressure


rather than to do the entire job with one pass. A gentle
touch gives the best control and reduces the chance of
error.
HOLDING THE TOOL




OPERATING SPEEDS






forward.

backward.








also helps to keep the preselected speed virtually constant
between no-load and load conditions.



or between any one of the settings.
The speed of Rotary Tool is controlled by setting this dial

25