User's Manual

User Manual
Version 01.00
2010-01-25
deRFmega128-22A001 and deRFmega128-22A021
dresden elektronik
ingenieurtechnik gmbh
Enno-Heidebroek-Str. 12
01237 Dresden
Tel.: 0351 – 31 85 00
Fax: 0351 – 3 18 50 10
[e-mail]
www.dresden-elektronik.de
Page 18 of 20
11. Radio Certification
11.1. United States (FCC)
The deRFmega128-22A001 and deRFmega128-22A021 complies with the requirements of
FCC part 15.
To fulfill FCC Certification requirements, an OEM manufacturer must comply with the follow-
ing regulations:
The modular transmitter must be labelled with its own FCC ID number, and, if the FCC ID is
not visible when the module is installed inside another device, then the outside of the device
into which the module is installed must also display a label referring to the enclosed module.
This exterior label can use wording such as the following. Any similar wording that expresses
the same meaning may be used.
Sample label for radio module deRFmega128-22A001:
FCC-ID: XVV-MEGA22A00
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must ac-
cept any interference received, including interference that may cause undesired operation.
Sample label for radio module deRFmega128-22A021:
FCC-ID: XVV-MEGA22A02
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must ac-
cept any interference received, including interference that may cause undesired operation.
To be used with the deRFmega128-22A021 module, the external antenna have been tested
and approved which is specified in here below. The deRFmega128-22A021 Module may be
integrated with other custom design antennas which OEM installer must authorize following
the FCC 15.21 requirements.
The Original Equipment Manufacturer (OEM) must ensure that the OEM modular transmitter
must be labeled with its own FCC ID number. This includes a clearly visible label on the out-
side of the final product enclosure that displays the contents shown below. If the FCC ID is
not visible when the equipment is installed inside another device, then the outside of the de-
vice into which the equipment is installed must also display a label referring to the enclosed
equipment.
This equipment complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation
(FCC 15.19). The internal / external antenna(s) used for this mobile transmitter must provide
a separation distance of at least 20 cm from all persons and must not be co-located or oper-
ating in conjunction with any other antenna or transmitter.