User Manual
Table Of Contents
- SAFETY INSTRUCTIONS
- BEFORE YOU BEGIN
- CONTROLS AND OPERATING INSTRUCTIONS
- Set unit upright
- Positioning a Dehumidifier
- Extend handle
- Set up drain hose
- NOTICE: Uncoil and straighten the entire drain hose. Do not leave any part of the hose coiled on the unit and do not place the end of the hose higher than 20 ft. (6 m) above the bottom of the unit. Also check for kinks or other obstructions that might...
- Plug in electrical cord
- HOW TO USE THE CONTROL PANEL
- Home Screen Views
- AT THE END OF THE JOB
- TRANSPORTATION AND STORAGE
- MAINTENANCE SCHEDULE
- Before each use
- Monthly
- As Needed
- Clean Pump Check Valve and Basin. This requires removal of the front housing.
- Fig. B: Disassembly for Cleaning
- TROUBLESHOOTING
- INSTRUCCIONES DE SEGURIDAD
- ANTES DE COMENZAR
- CONTROLES E INSTRUCCIONES DE OPERACIÓN
- Coloque la unidad en posición vertical
- Dónde colocar el deshumidificador
- Extienda el mango
- Instale la manguera de drenaje
- AVISO: Desenrolle y enderece toda la manguera de drenaje. No deje ninguna parte de la manguera enrollada en la unidad y no coloque el extremo de la manguera a más de 20 pies (6 m) por encima de la parte inferior de la unidad. Compruebe también que no ...
- Enchufe el cable eléctrico
- CÓMO USAR EL PANEL DE CONTROL
- Visualizaciones de la pantalla principal
- AL FINAL DE TRABAJO
- TRANSPORTE Y ALMACENAMIENTO
- PLAN DE MANTENIMIENTO
- Antes de cada uso
- Mensual
- Según sea necesario
- Limpie la válvula de retención de la bomba y el recipiente: Esto exige la extracción de la carcasa del frente.
- Fig. B: Desensamble para la limpieza
- RESOLUCIÓN DE PROBLEMAS
- INSTRUCTIONS DE SÉCURITÉ
- AVANT DE COMMENCER
- COMMANDES ET INSTRUCTIONS DE FONCTIONNEMENT
- Mettez l’unité debout en position verticale.
- Positionner un déshumidificateur
- Poignée d’extension
- Mise en place du tuyau de vidange
- Cet appareil pompe de l’eau automatiquement sur une base régulière. Ce déshumidificateur est équipé d’un raccord à connexion rapide pour l’attachement au tuyau de vidange fourni (12 m - 40 ft), situé sur le plateau sur le dessus de l’unité. Déballez l...
- NOTICE : Déroulez et redressez le tuyau de vidange entier. Ne laissez aucune partie du tuyau enroulée sur l’unité et ne placez pas l’extrémité du tuyau à une hauteur de plus de 6 m (20 ft), à partir du bas de l’unité. Vérifiez aussi qu’il n’y ait pas ...
- Brancher le câble électrique
- Affichages écran d’accueil
- À LA FIN DE LA TÂCHE
- TRANSPORT ET RANGEMENT
- PROGRAMME DE MAINTENANCE
- Avant chaque utilisation
- Tous les mois
- Si nécessaire
- Nettoyer le clapet antiretour de la pompe et le bac Cela nécessite le retrait du logement avant.
- Fig. B : Démontage pour le nettoyage
- DÉPANNAGE
108259F #103614 (F600) 6 Legend Brands, Inc.
TROUBLESHOOTING
FAULT CAUSE SOLUTION
Water drips out
when moving unit
Unit was unplugged before
purging was complete.
Purge unit before moving. See “At the End of the Job.”
Unit does not
operate
Unit not switched on.
No power to machine.
Switch unit on.
Plug in unit; check power cord connection at wall outlet and at
base of unit.
Unit operating,
but room not dry
Not enough time to dry.
Poor air movement in room.
Excessive moist air infiltration.
Make sure “Humidistat” is OFF.
Allow more time for drying.
Increase air movement with air movers.
Seal off area to reduce infiltration.
Unit collects too
little water
Room air is dry.
Room temperature is too low.
Filter is full.
Coils are clogged.
Make sure “Humidistat” is OFF.
Confirm humidity level with hygrometer.
Increase room temperature.
Check filter. Replace as necessary.
Check coils. Clean as necessary.
If the problem you are experiencing is not listed here, call your local distributor or contact
our Service Department at 800-932-3030 for further assistance.
SPECIFICATIONS
Model LGR 6000Li (#103614 (F600))
Water removal AHAM
(80°F/60% RH)
100 pts. | 47.3 L / day
Water removal saturation
(90°F/90% RH)
204 pts. | 96.5 L / day
Process air (max.) 320 CFM
Dimensions
(H × D × W)
32.1 × 19.8 × 20.0 in.
81.5 × 50.3 × 50.8 cm
Weight 103 lbs. | 46.7 kg
Amps 6.6A
Volts 115V
Frequency 60Hz
Power 759W
Operating range 33°F–100°F | 1°C–38°C
Noise level (avg.)
53 dB
Drain hose
40 ft. | 12.2 m
Power cord
25 ft. | 7.6 m
Construction
Rotomolded shell
Safety
ETL certified CSA 22.2 no. 92
Specifications are subject to change without notice. Some values
may be approximate.
*Fan speed varies automatically for optimized performance.
Order replacement air filters from your local distributor.
Part no. #100254 (F579) (24 pack).
Be sure to visit Warranty.LegendBrandsRestoration.com
and register your purchase. Your registration will help us
provide you with updated product information as needed.
For proper disposal, this unit should be taken to a
recycler licensed to process refrigeration equipment.
WARNING: This product and other substances
that may become airborne from its use contain
chemicals, including lead and phthalates, known to the
State of California to cause cancer, birth defects, or
other reproductive harm. For more information, go to
P65Warnings.ca.gov